1/1/2023 0 Comments Stm32x device protectedIn applications involving analog-to-digital conversion, ADC accuracy has an impact on the overall system quality and efficiency. A self-calibration feature is provided to enhance ADC accuracy versus environmental condition changes. In procedure 'program_error' called at file "embedded:startup.1 Application note How to get the best ADC accuracy in STM32Fx Series and STM32L1 Series devices Introduction The STM32Fx Series and STM32L1 Series microcontroller families embed up to four advanced 12-bit ADCs (depending on the device). In procedure 'program' called at file "openocd.cfg", line 11Įrror executing event reset-init on target stm32f4x.cpu:Įmbedded:startup.tcl:449: Error: ** Programming Failed ** Warn : STM32 flash size failed, probe inaccurate - assuming 1024k flash XPSR: 0x01000000 pc: 0xfffffffe msp: 0xfffffffcĮrror: Failed to read memory at 0x1fff7a24 Target halted due to debug-request, current mode: Thread In procedure 'ocd_process_reset_inner' called at file "embedded:startup.tcl", line 214 Info : Listening on port 3333 for gdb connectionsĮrror: Translation from khz to jtag_speed not implementedĮrror executing event reset-start on target stm32f4x.cpu: Info : stm32f4x.cpu: hardware has 6 breakpoints, 4 watchpoints Info : This adapter doesn't support configurable speed Anyone got any ideas on how I can fix? Also included is the openocd.cfg file. I have managed to get it to connect to the vesc (can be seen in the openocd output.txt) but it won't program due to the device being protected. From my research I found that this could perhaps be a firmware or bootloader issue so I have been trying to redo it using a raspberry pi running openocd and the GPIO pins connected to the vesc. It now only displays a blue light when on (no green like my other working vesc). I was riding my skateboard the otherday when it suddenly lost power and wouldnt reboot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |